 PARALLEL
AMPLIFIER LINK CABLE
It will allow you to connect 2 SCHERTLER Amplifiers
and to send the signal form one amp to another
just trough the Insert point only with ONE CABLE.
Cable length - 8 meter
Order code : CA-PALINK-8
 ACTIVE
DI
It will allow you to connect the output from acoustic
and electric guitars, guitar amps, keyboard, mixers,
tape machines and just about anything else directly
to the mixer, without using a microphone, and
with no hum loops.
Order code : ACTIVE-DI
 VOLUME
PEDAL
UNICO/DAVID volume control pedal, 3m long
Order code : UNI-PED
 ACTIVE
DRIVER CABLE
For the connection of passive pick-up systems
requiring high impedance input (passive piezo
systems, ellectric guitars and basses with magnetic
pickup). Active Driver Cable is a mono Jack with
one side modified electronics for rising input
impendence. Using it with a Unico amplifier, input
impedance is near to 500 Kohm. The red connector
is the active one, plug it into your amplifier
Jack input (Stat In).
Order code : CA-ADRIVER-4
 PHANTOM
POWER ADAPTER - FOR BASIK
For the connection of our pickup BASIK to a mixer
or to an acoustic amplifier input with 48V Phantom
Power.
 1.5V
ADAPTER - FOR BASIK
For the connection of our pickup BASIK to every
line input and any amplifier.
 CABLE
XLR-M/XLR 90°-F
For DYN-B transducer, 4m or 8m available
Order code: CA-XFRXM
 CA-CLIP
Clip to han a XLR connector on the belt
Order code: CA-CLIP
 PRE-CLIP
Clip to hang the STAT-PRE on the belt
Order code: PRE-CLIP
 CA-PC-25
Power cord cable from PUB 380 to PUB 280, 2.5m
Order code: CA-PC-25
|
